Keep ends of adjoining starter strips at least 1 4 inch apart to allow for expansion.
Putting up drip edge on trim siding attaching.
Install these fragile starter strips with a 15 gauge.
When installing the starter strips allow a 1 8 inch space for corner posts and j channels for expansion.
Without a drip edge water may end up beneath the shingles and may cause damage to various parts of the home.
This does two things it pushes the water a little further out away from the trim the flashing is protecting and it helps stiffen the bottom edge so it stay straight as the metal expands and contracts with temperature.
Nail in the center of the nailing slots.
At the sides of the casings jab your brush into joints then smooth out the paint to seal them.
Push one end of longer pieces into the trim then bow the siding slightly and guide the other end into the trim.
Paint a tight seal between metal and wood.
Space the fasteners by about 12 inches.
Above the bottom of the wall sheathing as a guide.
Find your most beat up pieces of siding and rip them down into 1 1 4 in.
Make sure the outer edge extends over the gutter.
Then slide it up and snap the butt into the locking edge of the piece below.
If it doesn t pull the drip edge out slightly from under the shingles.
Snap a line 1 in.
Create a drip edge.
Does the drip edge metal go under the tarpaper ice and water shield or underlayment on the eave.
As seen in m.
Feed the shorter pieces alongside the window into the channel at the top of the window and slide them down into position.
Some drip edge flashings actually help houses turn to mush.
And i include a 1 4 in.
T shape drip edge is an l shaped flashing in which the long leg folds back on itself before heading down 90 degrees to form the short leg.
These strips installed at the bottom will make your first row of siding angle out to match the rest of the rows.
At casings and for the undersides of siding laps you may prefer to use a corner roller.
Slip the wide flat flange of the material all the way under the first course of roof shingles as illustrated.
Get the real story about drip edge placement.
Turns out not all drip edge flashing perform the same.
Install the drip edge by fitting it on the roof eave pushing it tightly against the edge of the plywood and nailing or screwing it down.
Drip edges are metal sheets usually shaped like an l installed at the edge of the roof.
Use 1 inch galvanized roofing nails or 3 4 inch exterior screws.
Drip edge roof flashing types.
How to install a drip edge.
Outward kick along the bottom.
Secure the drip edge with roofing cement.
To seal the edge of a siding panel where it has been cut and to secure it to the wall you can use under sill trim.
At the top of each casing you ll find a drip cap or metal flashing that tucks up under the siding.
Overlap two pieces of flashing that meet end to end by at least 1 inch.
